Originally Posted by cooper barrett:
Did you see the RPMs and the new old stock engine? That engine ran sno mobiles, carts, saw and milling saws and post hole diggers... Shit it was 8HP at 7K rpm and rated highter.
THat same design is still made by another company.
This is a bad ass AB 820. note the expansion chamber.:-):-)
Haa that one would put some arms on ya. That fellow was walking pretty gingerly to the log. [Reply]
I've been talking about and planning a project for the last three years. I've got a lot left to do but with the help of a friend it's started. I'll start the cool part later today or tomorrow.
Lp. It wasn't any big deal and wasn't nervous at all. Remove the valve and there is a wide open hole to let any gas out and this one had been sitting for a long time.
On another note. A couple of months ago I replaced a broken heating element and 3 fuses as a precaution on our cloths dryer. It apparently burned out again today. Anyone have an idea what could be causing it? Maybe just a bad Chinese made replacement element? Debating trying to fix it one more time or just bite the bullet. [Reply]
Originally Posted by Iowanian:
I've been talking about and planning a project for the last three years. I've got a lot left to do but with the help of a friend it's started. I'll start the cool part later today or tomorrow.
Originally Posted by Iowanian:
Lp. It wasn't any big deal and wasn't nervous at all. Remove the valve and there is a wide open hole to let any gas out and this one had been sitting for a long time.
On another note. A couple of months ago I replaced a broken heating element and 3 fuses as a precaution on our cloths dryer. It apparently burned out again today. Anyone have an idea what could be causing it? Maybe just a bad Chinese made replacement element? Debating trying to fix it one more time or just bite the bullet.
Heating element or bad connection probably.
My buddy sells this stuff and I had a dryer that wasn't getting as hot as it needed to, and he said at 10 years old we could replace the element, but there is a bunch of other stuff that probably needs replaced too.
Just pull the trigger on a new one. He recommended Speed Queen. I'll vouch. Good unit. [Reply]
Originally Posted by Iowanian:
To have been working on my arts and crafts project a little more.
Very cool.
I flash burnt my eyes with the plasma last week. I swear it was worse than any welder burn and made for one terrible night. Took several days for my vision to clear up at a distance and I'm still wearing sun glasses when I shouldn't need them. [Reply]